MagnaFlow Conv DF 05-09 Toyota Tacoma 4.0L D/S Rear (49 State) - 93660

Features

• Sensor Port Count: 1
• Overall Length: 39.125
• Material: Stainless Steel
• Mounting Hardware Included: Yes
• Heat Shield Attached: No
• Substrate Material: Ceramic
• Converter Quantity: 1
• Finish: Stainless Steel
• Gasket Included: No
• Air Tube Adaptable: No
• Oxygen Sensor Location: Pre Converter
• Series: HM Grade
• Main Piping Diameter: 2.25
• Clamp Included: Yes
• Subtitle: HM Grade Direct-Fit
• Title: HM Grade Direct-Fit
• Type: Direct-Fit
• Outlet Attachment: Bolt-On
• Hangers Included: Yes
• Inlet Attachment: Bolt-On
• Keep the check engine light off with MagnaFlow HM Grade Federal/EPA Compliant Direct-Fit Catalytic Converter 93660. With features including free-flowing mandrel-bent tubing and highly corrosion resistant, stainless steel construction, easily install this spun body converter yourself using the proper tools, no cutting or welding required. MagnaFlow's state-of-the-art metrology department uses the latest 3D scanning systems during research and development, so you can be confident that your new part will fit and function like the original equipment. By replicating the OE spun body design, the single laser fusion weld greatly reduces the possibility of a leak, and our compact, low-mass design also allows for greater thermal efficiency.This direct-fit catalytic converter is designed specifically for the 2005-2015 Toyota Tacoma and interchanges with OE parts 17450-0P020 and 17450-0P030. The included gaskets & hardware reduce the possibility of a leaking seal while avoiding the need to reuse corroded factory parts for installation. This replacement part is designed to meet or exceed Federal emissions requirements set forth by the EPA, complying with legal standards for OBDII Federally registered vehicles with Federal/EPA Emission systems.