EBC Racing AP Racing CP3307 (CP3215D50 Brake Pad) Front Titanium Shim - SH002

These new perforated titanium heat insulation shims have been shown in laboratory tests to reduce heat transfer through the pads to the caliper by around 90??F.Install Instructions:

• Shims must be flat and sit without any gapping on the rear of the brake pad.
• If your pad set is supplied with any other shims such as the rubberised shims on most stock pads, these MUST be removed before fitting titanium shims to avoid a pad over-thickness situation.
• Simply prize the old shims off to break the adhesive seal with a blunt edge screwdriver or similar, and once removed lightly, sand the rear of the pad to remove any excess glue or surface irregularities. The new titanium shims MUST be snugged up against the pad backing plate without any debris between to avoid long pedal/brake sponge.
• Titanium shim sets for sliding calipers contain only two shims and these must each be applied to the pad located next to the piston. Titanium shims for multi-piston calipers are supplied for all four pads in the axle set.

• AP Racing CP3307
• AP Racing CP3799
• AP Racing CP5040-2
• AP Racing CP5040-30
• AP Racing CP5200
• AP Racing CP5830
• AP Racing CP5835
• AP Racing CP5880
• AP Racing CP6267
• AP Racing CP6320
• AP Racing CP6720
• AP Racing CP6730
• AP Racing CP6740
• AP Racing CP9200
• AP Racing CP9202
• AP Racing CP9440
• AP Racing CP9441
• EBC Brakes Racing Apollo-4 (100 Series)
• Hi- Spec Monster 4
• Hi- Spec Monster 6
• Hi- Spec Monster Race 4
• Hi- Spec Monster Race 6
• Hi- Spec R132-4
• Hi- Spec R132-6
• Hi- Spec RR132
• K-Sport 6 Pot
• K-Sport 6 Pot
• Lotus Carlton 3.6 1990-1994
• Lotus Esprit 3.5 1999-2003
• Lotus Esprit Sport 300 2.2 1993
• Noble M12 2.5 1999-2002
• Opel Omega Lotus 3.6 1990-1994
• Vauxhall Carlton 3.6 1990-1994