Snow Performance Gas Stage I The New Boost Cooler Forced Induction Water Injection Kit - SNO-201

The Snow Performance Stage 1 Boost Cooler?? water-methanol injection kit is available for all forced induction applications (supercharged/turbocharged). Operation is simple and reliable: the system starts injecting when the boost switch reaches the user-adjustable point and injects a fixed amount of fluid through the nozzle until boost goes below the set switch point. Proven to deliver 30-70 HP increases to all forced induction applications!

This makes it a good choice for low to medium boost setups (1-15 PSI) looking for an octane enhancement and cooler intake charge. Activation can also be set up through any other user-chosen switch, such as a full throttle switch, nitrous switch, etc.

Features:

• 300 PSI UHO (Ultra High Output) Pump
• 3 Quart Reservoir
• All Tubing Necessary for Installation
• 10' ?? Inch High Temp Nylon Tubing
• 18" High pressure Boost Line
• 3' (Black) Wire Loom
• Boost Switch (1-15 PSI)
• Pig Tail Harness
• Level Switch Upgrade
• 1 Nozzle Holder/Check Valve Combo
• 3 Hyper-Sonic??? Nozzles (175, 375, 625 ml/min)
• Required Hardware Needed For Installation
• Snow Performance Running S Decal
• Comprehensive Instructions to Install on Any Forced Induction Vehicle
• Snow Performance 1-Year Warranty
• High Pressure Boost Line is 12" Long
• Red High Temperature Line

• Forced Indution Engines